5 TIPS on designing RF PCBS

Rule One: Use Four Layers

It’s not obligatory to use 4 layers in RF design, “you can do 2-layer design but you better start reading” Michael said.  if you don’t like to do an advanced RF study of your circuit, then use 4-layer design and follow the signal stack below.

Rule Two: Use Integrated Components

Always try to find an integrated component that meets your application. for example, use transceiver ICs like: CC2650, CC1310, ADF7242, AT88RF215, nRF24L01+… etc.
Also use passive components like filters in a shape of integrated component which is much easier than design a discrete one.

Rule Three: Use 50 Ohm Everywhere

The reason to use 50 ohm is to do impedance matching. This include microstrip impedance calculation to know it’s resistance and Michael showed us how to calculate that using online tools.

Rule Four: Follow The Manufacturer Recommendations

Some times, the manufacturer will provide you with a reference circuit to match the impedance of output to 50 ohms, just follow this circuit!

rule4

Rule Five: Route RF First

Keep RF traces short and direct and keep other signals away from RF.